9-3 (9440) L4-2.0L Turbo (2007)
/l4-2.0l_turbo/Page-3061004.png)
4. Refit the carpet.
5. Refit the inner sill trim.
6. Fit rear seat cushion.
7. Connect the battery.
8. Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostics tool, delete any diagnostic trouble codes.
Switch off the ignition and then on again. Wait at least 1 minute with the ignition switched on.
Check whether a diagnostic trouble code is shown.
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostics instrument.
9. Carry out Measures after disconnecting the battery.
