9-3 (9440) L4-2.0L Turbo (2007)
/l4-2.0l_turbo/Page-766001.png)
Manifold Pressure/Vacuum Sensor: Description and Operation
Pressure Sensor, Intake Manifold (431)
Main task
During quick load changes, the engine load or air mass/combustion that is calculated based on values from the mass air flow sensor may differ from the
actual air mass sucked into the cylinder during the intake stroke. This is caused by the inertia of the large air volume in the intake system. Therefore,
intake pressure is used during load changes to correct the air mass/combustion used when calculating fuel quantity.
The pressure is also used to correct purging's PWM ratio. With high intake pressure, a greater PWM ratio is needed to maintain the same purge flow.
The value from the pressure sensor is also used as a substitute value for the mass air flow sensor if the diagnostic system has detected a fault in the mass
air flow sensor.
Type
The pressure sensor contains two metal plated ceramic discs mounted in close proximity. The disc located closest to the pressure connection is thinner
and bends when subjected to pressure. By this means, capacitance between the metal plating of the discs is changed based on the pressure.
Connection
