9-3 (9440) L4-2.0L Turbo (2007)
IMPORTANT: Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further
information regarding connectors, refer to Connectors, handling and inspection.
2. Plug in the control module connector, making sure the gear segment on the side of the connector is engaged. Connect the solenoid cable and the
ribbon cable.
3. Check the operation.
4. Fit the front part of the air duct.
5. Fit the front stay.
6. Fit the right side cover on the center console.
Perform After changing a control module.
Gear Position Panel With Cover Strip
Gear position panel with cover strip
To remove
1. Engage D with the selector lever.
2. Turn the locking sleeve slightly clockwise and press down. Hold in the release button on the selector lever and pull up the knob. Lift up the
locking sleeve.