9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-112005.png)
3. Put the assembly in place with the guide pin in the rubber bushing. Make sure the brake pipes are secured in the clips on the MacPherson strut
tower.
4. Fit the screws and ground line to the MacPherson strut tower. Ensure that the washer is placed under the cable shoe.
Tightening torque 25 Nm (18 ft. lbs.)
Important: Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information
regarding connectors, refer to Connectors, handling and inspection.
5. Attach the connector to the control module.
6. Refit the battery cover and battery.
7. If control module is changed: Carry out the procedure for changing the control module.
