9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-242004.png)
8. Fit the centre console's rear side panel.
9. Fit the centre console's front side panel.
10. Fit the passenger seat.
11. Perform the procedure for after fitting a control module.
12. Connect the battery.
13. Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 10 seconds with the ignition on. Check whether a diagnostic trouble code is shown:
If a diagnostic trouble code is shown:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If a diagnostic trouble code is not shown:
The assembly was successful. Disconnect the diagnostic tool.
14. Carry out Measures after disconnecting the battery.
