9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-3061003.png)
^
Contact roller (2)
^
Control module (3)
^
All seat belts with seat belt tensioners on the front seat used during the accident (4)
^
Both the seat belts on the outer seats. The seat belt for the center seat on the rear seat, if used during the accident (5).
^
The passenger side airbag (where appropriate) and the dashboard (6)
^
The side airbags, with respective sensors and backrest upholstery bags, which have been activated during the accident. (The side impact sensors do
not need to be replaced if there has been no mechanical damage to the sensor and if the sensor does not give a diagnostic trouble code) (7).
^
Front sensors, (The front sensors do not need to be replaced if there has been no mechanical damage to the sensor and if the sensor does not give
an trouble code) (8)
^
Inflatable curtains, which have been activated during the accident, with A-, B-, C-pillar trim and headlining
^
An activated roll bar (CV) which is visibly affected by external force or binds when being reset to its original position.
The following components should be checked with regard to burn damage and deformation:
^
knee shield
^
airbag system wiring harness
^
windscreen.
Replace damaged components.
WARNING:
^
Replace all seatbelts if it cannot be established without doubt which belts were in use when the accident occurred.
^
Always replace the seatbelt with belt tensioner on the passenger side if it was in use when the accident occurred.
