9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
/l4-2.0l_turbo_(2.0_t)/Page-2674001.png)
Stabilizer Bushing: Service and Repair
Anti-Roll Bar Bush, Rear
To Remove
1. Raise the car.
2. Detach the anti-roll bar from the steering swivel members.
3. Remove the anti-roll bar mountings from the subframe.
4. Remove the bushes from the anti-roll bar.
To Fit
1. Clean the anti-roll bar and grease the inside of the bushes with 30 20 476 Ball bearing grease. Fit the bushes to the anti-roll bar and fit the caps.
2. Fit the anti-roll bar to the subframe.
Tightening torque bolt 8-8 (flange diameter 15.2 mm): 18 Nm (13 ft. lbs.) and use thread locking adhesive, Loctite 242
Tightening torque bolt 10-9 (flange diameter 16.7 mm): 31 Nm (23 ft. lbs.).
