9-3 Coupe (9400) L4-2.0L Turbo (B204) (1999)
10
Undo the 3 throttle body retaining screws.
11
Lift up the throttle body, clamp and detach the 2 coolant hoses to the throttle body and detach the hose under the limp-home solenoid.
12
Detach the lower vacuum hose.
To fit
IMPORTANT
The limp-home solenoid will be activated when the ignition is turned on and the solenoid/throttle body is removed. After turning the ignition on, the
limp-home mechanism must therefore be reset as described in "Resetting triggered limp-home solenoid".
1
Fit the lower vacuum hose.
2
Fit the coolant hoses and remove the clamps.
3
Position the throttle body and screw it on with the 3 retaining screws. Fit a new seal if necessary and lubricate it with a thin coat of vaseline (part
no.30 20 271).
4
Attach the hose under the limp-home solenoid and fit the clip.
5
Tighten the 3 throttle body retaining screws.
6
Spray the throttle body 10-pin connector with Kontakt 61 (part no.30 04 520) and plug it in.