9-3 FWD (9440) L4-2.0L Turbo (B207R) (2009)
This procedure allows you to recreate the structure of visible unpainted surfaces after welding and sanding. This method can also be used to repair light
and very superficial scratches
NOTE:
^
Always use a gravity feed spray gun with the recommended nozzle (1.8 - 2.4 mm).
^
HVLP sprays also provide good results.
1. Sand the damaged area with abrasive paper (grade 400 - 500).
2. Clean the part with Teroson FL cleaner.
3. Mask the part so that only the damaged area is visible.
4. Start by priming the damaged area with two layers of a surface structure treatment mixture.
Mixture:
70% Terotex 3000 (white or black)
20% 2K paint
To maintain durability, 2K paint must always be used, even for black or white products.