9-3 FWD (9440) L4-2.0L Turbo (B207R) (2009)
3. Fold up the left-hand inspection cover (A).
4. Fit the Boot lid trim.
5. Fit the C-pillar trim.
6. Connect the negative cable of the battery.
7. Set the clock and program any radio code.
8. Cars with pinch protection: Carry out Programming the pinch protection.
IMPORTANT: Fasten the wiring harness correctly so that there is no risk of it chafing or rattling.
NOTE: Spray all the connectors with "Kontakt 61" to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.
Wiring Harness, Engine
Wiring Harness, Engine B207
To remove
1. Remove the bottom of the battery cover.
2. Detach the top section of the electrical centre (A) from the lower section (342).