9-3 Hatchback (9400) L4-2.0L Turbo (B205) (2000)
1. Fit the reverse gear detent to the ball socket.
2. Press down the ball socket into the lever housing. Make sure that the O-ring is correctly positions
3. Refit the gaiter.
Gear Lever
To remove
1. Remove the gear lever housing.
2. Remove the lock plate holder.
3. Remove the spring securing the lock plate.
4. Use a screwdriver to disengage the pawl which is controlled from the ignition switch. Lift up the lock plate together with its plastic bracket.
5. Remove the deflection limiter.
6. Set the gear lever to reverse and undo the screw securing the selector rod to the gear lever.
7. Remove the gear lever and ball socket by carefully pressing in the three tabs on the socket using a screwdriver.