9-3 SE Convertible (9400) L4-2.0L Turbo (B205) HO (2001)
/l4-2.0l_turbo_(b205)_ho/Page-3236002.png)
The parking lights are controlled by TWICE which gives information to the bus (ON/OFF). The message ON corresponds to switch position 1 and the
message OFF corresponds to switch positions 1 or 2.
DICE pin 39 is connected to switch pin 5, which corresponds to position 0. DICE pin 15 is connected to switch pin 4, which corresponds to position 2.
Pin 2 on the light switch is supplied with voltage +54 via fuse 15. The power is fed on from the light switch pin 10 to DICE pin 39, thus grounding the
dipped beam relay via DICE pin 4 and the relay closes. Power is fed through the relay via the filament monitor and on to the dipped beam lamps which
are turned on.
Filament monitor
The filament monitor is located in the engine bay (relay box). It detects any breaks in the circuit to the lamps by measuring the current in the circuit. In
the event of an open circuit, the filament monitor pin 5 grounds pin 10 on the SID unit. SID displays the message FRONT LIGHT FAILURE.
Diagnosis
DTC 1160 is generated when there is an open/short circuit to ground or a short circuit to B+.
DTCs are not generated if the voltage is below 11 V or during diagnostic communication.
