9-3 SE Convertible (9400) L4-2.0L Turbo (B205) HO (2001)
16. Fit the front section of the high-pressure pipe.
17. Lubricate the new O-rings with synthetic vaseline and fit them on the pipes by the receiver dryer PAD-connection.
18. Fit the pipes in the PAD-connection by the receiver dryer.
19. Tighten the bolt that secures the pipes to the PAD-connection.
Tightening torque 9 Nm (7 lbf ft)
20. Lubricate an O-ring with synthetic vaseline and fit it in the joint between the front and rear section of the high-pressure pipe.
21. Join the front and rear section of the high-pressure pipe.
Tightening torque 11 Nm (8 lbf ft)
22. Fit the high-pressure pipe in the brackets on the bulkhead and on the wheel housing.
23. Fit the power steering fluid reservoir and tighten the bolt.