9-3 SE Convertible (9400) L4-2.0L Turbo (B205) HO (2001)
4. Undo the 2 upper nuts on the joint between the turbocharger and the front exhaust pipe.
5. Raise the car.
6. Undo the lower nut on the joint between the turbocharger and the front exhaust pipe as well as the bolt on the catalytic converter brace.
7. Remove the clamp at the joint between the front exhaust pipe and the intermediate pipe.
8. Unhook the exhaust pipe from its rubber mountings and lower it away. Make sure that the leads of the oxygen sensors are not caught up or
damaged when the exhaust pipe is removed.
IMPORTANT The flexible section in the front part of the exhaust pipe must not be bent more than 5°.
To fit
IMPORTANT The flexible section of the exhaust pipe is sensitive to bending and must not be angled more than 5° as this could lead to
permanent deformation.
Do not allow the catalytic converter to hang from the flexible section.
1. Clean the joints.