9-3 XWD (9440) L4-2.0L Turbo (2011)
The location of the relays is stated in brackets below the component number.
Note: in numbers are the numbers imprinted on the top of the relay box, not the pin numbers on the relay.
When the box around the component is drawn with a solid line, the whole component is shown.
When the box around the component is drawn with a broken line, only part of the component is shown.
On some components having cable tails, the connector has not been given a separate H number to show that it is part of the component.
For components with more than one connector, the position of the connectors are usually indicated with a K plus a number, e.g. K22. This means that the
connector has 22 pins.
The components are designated by a serial number and one or more supplementary letters, which indicate their location or type. The location is indicated
by capital letters, e.g. 298FL, while the type is indicated by lower case letters, e.g. 47a. The following abbreviations are used to indicate position:
C = Centre
D = Driver side
F = Front
H = Hatch (boot lid/tailgate)
P = Passenger side
R = Rear
LH = Left Hand
RH = Right Hand
In the section "Electrical System - Wiring harness -Component location" there are illustrations of components' connector housings.