9-3 XWD (9440) L4-2.0L Turbo (B207R) (2009)
Impact Sensor: Service and Repair
Impact Sensor, Side, Rear (328RD, 328RP)
Impact Sensor, Side, Rear (328RD, 328RP)
WARNING: Read through Safety and handling instructions and Before removing a control module before starting work.
To remove
WARNING: The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery
before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe
personal injuries.
1. Turn the ignition key to the position LOCK.
2. Remove the rear seat.
3. Remove the rear scuff plate.
4. Dismantle the side impact sensor's connector.
5. Loosen the screws a few turns. Press together the locking clips on the outer part of the sensor. Press up the lower part of the sensor and pull out the
sensor.
To fit
1. Fit the side impact sensor by placing the sensor in its position. Pull down the lower part of the sensor. Tighten the screws.