9-5 (9600) L4-2.3L Turbo (B235) (2001)
/l4-2.3l_turbo_(b235)/Page-1885057.png)
12. Refit the left-hand front wing liner.
13. Refit the left-hand front wheel.
14. Refit the splash guard.
15. Lower the car to the floor.
16. Fill up with coolant. Close the filler cap.
17. Start the engine, activate the heater and warm it up.
18. Check the coolant level and coolant freezing point. Top up as necessary.
Safety Rules
Safety Rules
WARNING!
Work carried out when repairing the heater also involves the car's fuel system. The following points should therefore be observed when
carrying out repair work:
^
Always work in well ventilated premises. If approved equipment for the extraction of exhaust fumes is available, make sure that it is used.
^
Used protective gloves! Prolonged contact with fuel can cause skin irritation.
^
Keep a Class BE fire extinguisher near at hand. Be mindful of the danger of sparks when disconnecting electrical wiring, short circuits,
etc.
^
No smoking.
^
Never use the heater in closed premises such as garages and workshops unless exhaust extraction equipment is used.
^
The heater must always be turned off at petrol stations and the like.
^
When electric welding is carried out on the vehicle, the positive cable should be disconnected from the battery and connected to ground.
This is in order to protect the control module.
Water Pump
Water Pump
To remove
