9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
/l4-2.3l_turbo_(2.3t)/Page-2090001.png)
Brake Rotor/Disc: Procedures
Refinishing Brake Rotor, Off Vehicle
Grinding (turning) a brake disc, removed
Lathe "VBG 600" and the "accessory 26" connecting plate were used in the development of this method.
1. Remove the brake disk.
2. Measure the disc.
3. Clean the mating surface.
4. Fit the connecting plate on the lathe.
5. Back off the adjusting screws.
Clean the connecting surface and fit the brake disc to the connecting plate, connect the lathe.
6. Adjust the turning tools against the disc with the tool holder. Remove the locking screw and move the holder.
