9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
/l4-2.3l_turbo_(2.3t)/Page-1545003.png)
13. Loosen the cable and bend them to one side.
IMPORTANT: Secure each injector clip with a narrow cable tie. Make sure that it is correctly fitted and then tighten it. If this is not done, the
injectors could come loose from the fuel rail during the flow test.
14. Clean the area round the injectors with compressed air.
15. Remove the fuel rail retaining bolts.
16. Disconnect the pressure regulator's vacuum hose.
17. Carefully prise loose the rail using 2 pry bars or similar tools.
18. Carefully lift the rail up and away.
19. Plug the nozzle orifices.
To fit
NOTE: Apply non-acidic vaseline to the O-rings to assist fitting.
1. If necessary, fit new O-rings to the injectors. Remove the plugs from the injector orifices and fit the fuel rail and injectors.
