9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
1. Remove the gear lever.
2. Mount the gear lever in a vice.
3. Attach tape around the carrier, directly under the knob, to prevent it being damaged or scratched when it is being removed.
4. Place a 32 mm open-ended spanner under the edge of the knob. Carefully tap the hammer from underneath using a hammer. Lift off the knob and
carrier.
5. Remove the tape. Remove the knob from the carrier by using a small screwdriver to press in the three plastic lugs on the carrier (located under the
numbers 1, 5 and 4 on the knob). Note the steel spring under the knob.
IMPORTANT: A gear lever knob which has been removed must not be refitted but replaced with a new one.
To Fit