9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
The washer must not be forced into place. The space between the bush and the body should be at least 0.5 mm bigger than the thickness of the
washer. If the space is less than 2.5 mm, do not fit a washer.
20.
Lift the subframe enough that the bush is pressed against the body. Fit the screw.
Note
Make sure the bush is not rotated out of its position when tightening.
Tightening torque 100 Nm + 45° (75 lbf ft + 45°)
21.
Remove the screw from the centre bush on the right-hand side of the subframe.
22.
Mark the position of the bush with a dash to check that it is not rotated when the screw is fitted.
23.
Place a 2 mm thick washer between the bush and the body if it can be done without forcing it in.
Note
The washer must not be forced into place. The space between the bush and the body should be at least 0.5 mm bigger than the thickness of the