9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
3. Fit the brake hose to the pipe
4. Fit the clip.
IMPORTANT: Bear in mind the twisting of the hose so that it is not refitted incorrectly.
Fit the brake pads.
5. Lower the car slightly, remove the brake pedal clamp and put the fuse back in its holder.
6. Bleed the brake system, refer to Brake Bleeding, Service and Repair.
7. Fit the rear wheels and tighten the wheel bolts, using a torque wrench.
Tightening torque 110 Nm (80 ft. lbs.).
IMPORTANT: The wheel must hang freely when the wheel bolts are being tightened.
8. Lower the car to the floor and depress the brake pedal to force out the brake pistons.
9. Gheck the brake fluid level and top up as necessary.
Hydraulic Body Recondition
To Dismantle
1. Remove the brake pads.
2. Remove the hydraulic body.
3. Clean the hydraulic body.