9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
6.
Fit the screw and the 2 clips to the left-hand side of the heat exchanger housing.
7.
Fit the collar to the air outlet.
8.
Fit new 0-rings greased with synthetic vaseline, part no. 30 15 286, on the heat exchanger pipes and fit the pipes to the heat exchanger. Exercise
care that the 0- rings are not damaged.
Tighten torque 3.5 Nm (2.6 lbf-ft.).
9.
Remove the stepping motor from the old air distributor housing and remove the control rod from its clip.
Note
The old control rod shall not be used with fitting.