9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
4.
Fit the new cover with the 4 screws at the rear air distribution valve. Start with the upper rear screw, then with the lower rear screw.
Tightening torque 1.4 Nm (1 lbf-ft)
NOTE
Make sure that the air shield on the heat exchanger housing is set against the seal (certain models) and the guide inside the evaporator casing
when the heat exchanger housing is fitted.
5.
Fit the new heat exchanger housing onto the evaporator casing and fit the 4 screws and the 2 clips to the front and right-hand side of the heat
exchanger housing.
Tighten torque 1.4 Nm (1 lbf-ft).