9-5 SE Sedan (9600) V6-3.0L Turbo (B308) (1999)
/v6-3.0l_turbo_(b308)/Page-1710001.png)
Differential Axle Housing: Service and Repair
Left Hand Side
To Remove
1. Raise the car and remove the wheel.
2. Detach the drive shaft from the gearbox. Use tool 87 92 616.
3. Remove the clips for the brake hose and the mountings for the ABS lead.
4. Remove the screw securing the ball joint to the steering swivel member. Pry loose and lower the suspension arm.
Fixate position with a wooden block placed between the suspension arm and anti-roll bar.
IMPORTANT: Place a vessel under the transmission casing to avoid oil spill on the floor.
5. Turn the wheel to the right to facilitate extracting the drive shaft. Grip the MacPherson strut and pull. The drive shaft will come with it. Then, let it
tilt down in front of the suspension arm.
6. Remove the seal with puller 87 92 350 and back stop 87 91 683.
Fitting
