9-5 SE Wagon (9600) V6-3.0L Turbo (B308) (2001)
/v6-3.0l_turbo_(b308)/Page-1889004.png)
5. Fasten the pipe with the holders on the structure.
6. Position the front end of the high-pressure pipe.
NOTE: Start by inserting the right-hand end of the pipe from left to right down under the compressor. If the pipe is located correctly, it should
now fall in place.
7. Remove the plugs and lubricate the O-rings on both ends of the high-pressure pipe.
8. Connect the pipe's PAD connector to the receiver.
Tightening torque: 8 Nm (5.9 ft. lbs.)
9. Fasten the pipe with the holders on the subframe.
10. Adjust the oil volume in the compressor.
