9-5 SE Wagon (9600) V6-3.0L Turbo (B308) (2001)
/v6-3.0l_turbo_(b308)/Page-904003.png)
-
Cruise control is blocked.
Speed, Lead From ABS
Speed, Lead From ABS
The ABS control module sends a speed signal to pin 64 of the Trionic T7 control module. The signal is a square wave that varies between 0 V and B+ 29
times per wheel rotation. This speed signal is used to:
-
prevent adaptation of idle speed control when the car is moving.
-
on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel
shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.
-
activate speed limitation by limiting the maximum air mass/combustion at 240 km/h.
Diagnostics
-
If there is no speed signal, diagnostic trouble code P0502 will be generated.
-
If the speed value is implausible, diagnostic trouble code P0501 will be generated.
System reaction to a fault
-
The speed (bus from MIU) is used as a substitute value.
-
Cruise control is blocked.
System Overview
