9-7X L6-4.2L (2008)
6. Engage the sliding latch fastening the BCM to the rear electrical center.
Slide the latch outboard until the locking tab (1) is fully seated.
7. Install the rear electrical center cover.
8. Position the left hand second seat to a passenger position.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
10. If installing a replacement BCM, program the BCM. Refer to Control Module References (See: Testing and Inspection/Programming and
Relearning/Control Module References).