9-7X L6-4.2L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
5. Install the inflatable side impact module to the seat back frame with 2 screws (1).
Tighten the side impact module screws to 9 Nm (80 in. lbs.).
6. Install the seat belt and retractor assembly. Refer to Front Seat Belt Replacement (See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Front Seat Belt).
7. Install the lumbar assembly. Refer to Front Seat Lumbar Support Replacement (See: Power Seat Motor/Service and Repair/Front Seat Lumbar
Support Replacement) or Lumbar Support Cable Replacement (See: Service and Repair/Lumbar Support Cable Replacement).
8. Install the front seat back panel. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement (See: Driver Seat and
Passenger Seat Back Cushion Finish Panel Replacement).
9. Install the seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement (See: Front Seat Back Cushion Cover
and Cushion Pad Replacement).
10. Install the front seat back. Refer to Front Seat Back Replacement (See: Front Seat Back Replacement).
11. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement (See: Seat Cushion/Service and Repair/Seat Cushion Outer Trim
Panel Replacement).
12. Install the seat assembly to the vehicle. Refer to Front Seat Replacement - Bucket (See: Service and Repair/Front Seat Replacement - Bucket).
Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement
Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement
Removal Procedure
1. Remove the front bucket seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket (See: Service and Repair/Front Seat
Replacement - Bucket).
2. Remove the front seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement (See: Front Seat Back Cushion
Cover and Cushion Pad Replacement).
3. Remove the lumbar cables from the panel clips.
4. Remove the 2 push-pin fasteners (1) from each side of the panel.