9-7X L6-4.2L (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Ring Replacement
Rear Wheel Speed Sensor Ring Replacement
Tools Required
*
J 8092 Driver Handle
*
J 21128 Axle Pinion Oil Seal Installer
*
J 23690 Bearing Installer
*
J 2619-01 Slide Hammer
*
J 45857 Tone Wheel and/or Bearing Remover
*
J 45860 Tone Ring Installer
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement (See: Rear Wheel Speed Sensor Replacement).
4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6/9.5 in lD axle) (See: Transmission and
Drivetrain/Differential Assembly/Differential Cover/Service and Repair).
5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair).
6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857 (1) and the J 2619-01 (2).
Installation Procedure
