9-7X L6-4.2L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the water pump and secure the water pump with the bolts.
*
On the initial pass, tighten the bolts to 4 Nm (35 in. lbs.).
*
On the final pass, tighten the bolts to 10 Nm (89 in. lbs.).
3. Install the water pump pulley.
4. Install the water pump pulley bolts.
5. Using the J 41240, secure the water pump pulley while tightening the water pump pulley bolts.
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Remove the J 41240.
7. Install the drive belt. Refer to Drive Belt Replacement (See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair
).
8. Install the fan and the shroud. Refer to Cooling Fan and Shroud Replacement (See: Radiator Cooling Fan/Service and Repair).
9. Fill the cooling system with the specified coolant and concentration. Refer to Cooling System Draining and Filling (LL8) (See: Service and
Repair/Cooling System Draining and Filling)Cooling System Draining and Filling (LH6) (See: Service and Repair/Cooling System Draining and
Filling).
10. Inspect for leaks.