9-7X L6-4.2L (2008)
Engine Mount: Service and Repair
Engine Mount and Bracket Replacement - Right Side
Engine Mount and Bracket Replacement - Right Side
Tools Required
J 46406 Fan Clutch Remover and Installer
Removal Procedure
1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
2. Disconnect the fan clutch electrical connector.
3. Using J 46406 remove the cooling fan clutch from the water pump pulley and leave loose inside of the fan shroud.
4. Remove the manifold absolute pressure (MAP) sensor electrical connector and retainer (1).
5. Remove the MAP sensor (2).
6. Remove the right shock module, if frame engine mount is being removed. Refer to Shock Absorber and Spring Assembly Replacement (See:
Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Front Suspension/Shock Absorber and Spring
Assembly Replacement).
7. Remove the right and the left upper engine mount nuts (1).
8. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
9. Remove the right and the left lower engine mount nuts.
10. Remove the engine protection shield. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and
