9-7X V8-5.3L (2005)
Cowl Moulding / Trim: Service and Repair
Air Inlet Grille Panel Replacement
Removal Procedure
1. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (See: Wiper and Washer Systems/Wiper Arm/Service and
Repair/Windshield Wiper Arm Replacement).
2. Remove the air inlet grille panel retaining nuts.
3. Remove the air inlet grill panel retainers.
4. Remove the fixed antenna mast. Refer to Fixed Antenna Mast Replacement (See: Accessories and Optional Equipment/Antenna/Antenna
Mast/Service and Repair).
5. Disconnect the washer hose (2) at the coolant recovery tank.
6. Remove the air inlet grille panel from the vehicle, by pulling upwards and to the rear in order to disengage the retaining clips.
Installation Procedure
1. Position the air inlet grille panel to the rear edge of the hood.
2. Push downward on the air inlet grille panel to seat the retaining clips.