9-7X V8-5.3L (2005)
Paint: All Technical Service Bulletins
Body/Paint - Paintless Dent Repair Recommendations
Bulletin No.: 99-08-51-001A
Date: November 21, 2005
INFORMATION
Subject:
Paint-less Dent Repair Process
Models:
2006 and Prior GM Passenger Cars and Trucks
2003-2006 HUMMER H2
2006 HUMMER H3
2005-2006 Saab 9-7X
with Steel Outer Body Panels
Supercede:
This bulletin is being revised to add model years, models and update the information. Please discard Corporate Bulletin Number 99-08-51-001 (Section
08 - Body and Accessories).
The process of removing dents from vehicles without painting has been around for many years. Over the past several years, General Motors has
evaluated many versions of this process. Most versions were found to be unacceptable because of the potential long-term durability concerns. However,
a new type of repair process has been identified. This process uses special tools requiring no drilling of holes or removal of vehicle components for
access. This process is appropriate for the majority of panels with reasonable access to the back side of the damaged area. The special tools and
procedures that have been developed will remove the dents while eliminating the need to fill, paint, or replace the panel. This type of procedure has been
thoroughly evaluated and the repaired parts were tested for negative impact. No negative impact was found.
Important:
The removal of structural components or drilling of holes in any panel is not recommended and may void the General Motors Corrosion Warranty.
Evaluating Damage
Appropriate uses for paint-less dent repair include the following conditions:
^
Dents with no broken paint on the surface. Be sure to inspect for cracks with a 4x magnifying glass.
^
Large or small dents, creases or buckles, small sharp dents and soft dents in body lines and contoured areas that allow reasonable access to the back
side of the damaged area.
^
Dents that do not require structural part removal.
Inappropriate uses for paint-less dent repair include the following situations:
^
Dents that include cracked paint.
^
Dents that require holes to be drilled.
^
Dents that require structural parts to be removed.
^
Sharp dents in contoured areas, dents on the edge of panels, or dents in zero-clearance areas.
Tools
Use tools that are high-quality, tempered steel with smooth polished, rounded tips. These will not damage the back side of the dented area. Typically,
these tools are shaped and bent in order to allow access to most areas of the vehicle without drilling holes in the body as well as provide a clear view of
the work area. Specialty lights are also used to highlight damaged areas.
