9-7X V8-5.3L (2005)
Important: DO NOT reuse the old copper gaskets. Use only NEW copper gaskets.
1. Install the NEW copper gaskets to the brake hose and bolt.
2. Assemble the brake hose fitting bolt to the brake hose fitting.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the brake hose assembly to the caliper.
Tighten the fitting bolt to 40 Nm (30 ft. lbs.).
4. Install the brake hose bolt to the frame.
Tighten the bolt to 20 Nm (15 ft. lbs.).
5. Remove the rubber cap or plug from the brake pipe fitting.