9-7X V8-5.3L (2005)
13. Remove the compressor hose assembly from the condenser.
14. Remove the compressor hose assembly.
15. Remove the compressor hose from the A/C compressor.
16. Remove the compressor hose from the condenser.
17. Disconnect the electrical connector from the A/C low pressure switch.
18. Remove the nut from the compressor hose at the accumulator.
19. Remove the compressor hose from the accumulator.
20. Remove the compressor hose from the vehicle.
21. Discard all of the used sealing washers. Cap the system openings.
Installation Procedure
1. Install the compressor hose assembly.
2. Install the compressor hose to the condenser using new sealing washers. Refer to Sealing Washer Replacement (See: Coupler HVAC/A/C Coupler
O-ring/Service and Repair/Sealing Washer Replacement).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the compressor hose nut to the condenser.
Tighten the nut to 16 Nm (12 ft. lbs.).
4. Connect the electrical connector to the A/C low pressure switch.
5. Install the compressor hose to the accumulator using new sealing washers. Refer to Sealing Washer Replacement (See: Coupler HVAC/A/C
Coupler O-ring/Service and Repair/Sealing Washer Replacement).
