9-7X V8-5.3L (2005)
7. Install the EVAP/fuel hose/pipe bracket (6) to the bellhousing stud.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
8. Install the EVAP/fuel hose/pipe bracket nut (5).
Tighten the nut to 10 Nm (89 in. lbs.).
9. Use the following procedure if the vehicle is equipped with 4WD:
1. Install the EVAP/fuel hose/pipe assembly to the retaining clips (1) on the transmission.
2. Raise the transmission to the normal installed height.
3. Install the transmission support. Refer to Transmission Support Replacement (See: Body and Frame/Frame/Cross-Member/Service and
Repair/Transmission Support Replacement).
4. Remove the transmission jack.
5. Install the transfer case. Refer to Transfer Case Assembly Replacement (See: Transmission and Drivetrain/Transfer Case/Service and
Repair/Removal and Replacement/NVG 120-NR9 - Transfer Case/Transfer Case Assembly Replacement).
6. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Transmission and Drivetrain/Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement).