9-7X V8-5.3L (2005)
6. Place the top half of the J 41048 on the bottom half.
7. Inspect to make sure there are no pinch points on the boot before proceeding.
8. Insert the bolts (2).
9. Tighten the bolts (2) by hand until snug.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
10. Align the following items:
*
The boot
*
The halfshaft bar
*
The swage clamp
Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
11. Loosen the bolts.
12. Separate the dies.
Important: If deformities exist in the swage clamp, place the swage clamp back into J 41048. Ensure the swage clamp covers the whole
swaging area. Re-swage the swage clamp.
13. Inspect the swage clamp for any "lip" deformities.
