9-7X V8-5.3L (2005)
Torque Converter Clutch Solenoid: Service and Repair
Torque Converter Clutch Pulse Width Modulation Solenoid, Torque Converter Clutch Solenoid, and Wiring Harness
Tools Required
J 28458 Seal Protector Retainer Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the transmission oil pan and the filter. Refer to Automatic Transmission Fluid and Filter Replacement (See: Automatic
Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic Transmission Fluid and Filter Replacement).
3. Disconnect the transmission harness 20-way connector from the transmission internal harness pass-through connector.
Depress both tabs on the connector and pull straight up. Do not pry the connector.
Important: Removal of the valve body is not necessary for the following procedure.
4. Remove the 1-2 accumulator assembly. Do not remove the spacer plate. Refer to Accumulator Assembly, Spacer Plate, and Gaskets (See:
Automatic Transmission/Transaxle/Accumulator/Service and Repair).
5. Disconnect the internal wiring harness electrical connectors from the following components:
*
Transmission fluid pressure switch (1)
*
1-2 shift control solenoid (2)
*
2-3 shift control solenoid (3)
*
Pressure control solenoid (4)
*
torque converter clutch (TCC) pulse width modulation (PWM) solenoid (5)
*
3-2 control solenoid (6)