9-7X V8-6.0L (2008)
*
Manifold absolute pressure (MAP) sensor fault
*
Accelerator pedal position too high, electronic throttle control
*
Piston protection active, knock detected
*
Engine oil temperature out of range
*
Engine oil pressure out of range
*
Engine oil aeration present
*
Engine metal over temperature protection active
*
Accelerator pedal position rate of increase too high, electronic throttle control
*
Cylinder deactivation solenoid driver circuit fault
*
Engine coolant temperature sensor fault
*
Catalytic converter over temperature protection active
*
Brake booster vacuum pressure low
*
Brake Booster Vacuum Pressure Sensor Fault
*
Axle torque limiting active
*
Brake torque management active
*
Vehicle speed sensor fault
*
Engine coolant temperature too high
*
Engine not running
*
Vehicle speed not zero
*
Engine coolant temperature low
*
Reduced Engine Power Active, electronic throttle control
*
Transmission gear incorrect
*
Transmission range incorrect
*
Ignition voltage out of range
*
Maximum V4 mode time exceeded
Listed below are the powertrain conditions that will inhibit a cylinder deactivation solenoid from being energized, with the ignition ON and the engine
OFF, while using the scan tool output control function:
*
Engine speed not zero
*
Vehicle speed not zero
*
Transmission not in park or neutral
*
Ignition voltage out of range
For the system description covering the hydraulic/mechanical system of cylinder deactivation, refer to Cylinder Deactivation (Active Fuel Management)
System Description (5.3L) ().