9-7X V8-6.0L (2008)
12. Stake the other end of the retainer:
1. Remove the punch, part of J 41340.
2. Rotate the punch, part of J 41340, 180 degrees.
3. Hold the punch, part of J 41340, squarely against the end of the punch slot on J 41340.
4. Stake the metal over the other end of the retainer.
13. Loosen the holding screw.
14. Remove the cylinder from the J 41340.
15. Inspect that the retainer is properly staked. Restake as needed.
16. Lubricate the cylinder retainer slot.
17. Insert the following parts into the cylinder retainer slot:
^
The retainer spring (2)
^
The retainer (3)
18. Lubricate the following parts with GM P/N 12345996 or equivalent as needed:
^
The detent pins (1)
^
The cylinder retainer (3)
IMPORTANT: Use a paste type grease, not a spray, for the following step.
SIDE DOOR LOCK CYLINDER CODING
The side door lock cylinder has five snap-in tumblers. The number 1-5 positions (beginning closest to the cylinder head) is a brass retainer tumbler.
The 6-10 positions are standard tumbler positions. Therefore, only the 6-10 positions are required.
