900 L4-1985cc 2.0L DOHC (1986)
3.
Mount bracket on module using two (2) machine screws (Fgure 2).
For -1988 models, proceed to stop 7. For Convertible models, proceed to stop 8.
4.
On 1989- models, a 10-pin test socket and bracket must be moved to the right a distance of 55 mm.
5.
Using the bracket as a template, drill two 7 mm (9/32") holes as per the drawing (Figure 3).
6.
Mount bracket with existing hardware.
Caution:
When remounting the bracket, be sure the plastic fuel lines are not pinched between the bracket and seat beam.
7.
Using the module bracket as a template, drill two (2) holes 3.5 mm (9/64") as per drawing. Do not mount at this time (Figure 4).
Note:
On Passive Belt Cars, lift wires in seat beam and slide module under harness before drilling for proper positioning.
8.
Convertible models only: