900 L4-1985cc 2.0L SOHC Turbo VIN S FI (1984)
10.
Install the 4.8 x 19 mm screws through the mud flaps into the lower inner corners of the bumper extensions. Align mud flaps and bumper
extensions before securing the screws.
NOTE:
In extreme cases of fitting difficulty it may be necessary to enlarge or elongate the holes in the mud flaps to achieve a good fit with
the bumper extension.
11.
Drill a 1/16" hole through the mud flaps and bumper extentions near the top. Install a #8 x 1/2" screw* through each of the mud flaps and
bumper extensions into the inner part of the wheel arch moldings. (These screws replace the small T-10 torx screws which were removed).
12.
Drill a 1/16" hole through the mud flaps and bumper extension, near the bottom of the bumper extentions, and install a #8 x 1/2" screw* into
each hole.
13.
Reinstall the wheels.
Wheel Lug Bolts
65-80 ft.lbs.
*
These screws were not supplied in early kits.