900 L4-1985cc 2.0L SOHC Turbo VIN S FI (1984)
Differential: Adjustments
Checking After Shimming
CHECKING AFTER SHIMMING
After shimming, replace the measuring jig in the differential bearing seats and check that the correct reading is obtained on the dial indicator (+/-
0.05 mm or 0.002 in). If not, the shim thicknesses must be re-adjusted.
If the pinion is marked +3, the dial indicator reading should be +0.03 mm (0.001 in). The tolerance on this reading is +/- 0.05 mm (0.002 in).
To Check The Measuring Jig
The measuring jig is a precision tool. It should be handled with great care to avoid bruising and deformation. If damage to the measuring jig is
suspected, so that the wrong readings are obtained during measurement, the jig can be checked. The dimension shown in the figure should then be
checked.