900 L4-1985cc 2.0L SOHC Turbo VIN S FI (1984)
Drive Chain: Service and Repair
Primary Chaincase
The primary chaincase is removed in conjunction with the removal of the gearbox. When removed from the gearbox, the primary chaincase contains the
following parts: A. Ball bearing, B. Needle bearing, C. Clutch shaft seal, D. Level control ball valve and tubular dowel. Remove these parts as follows:
BALL BEARING
TO REMOVE
1. Remove the bolts and remove the ball bearing retainer.
2. Use drift 83 90 106 and sleeve 83 90 148 to press out the ball bearing.
TO FIT
1. Use tool 83 90 114 to press the bearing into the primary chaincase.
2. Fit the bearing retainer. Apply Loctite to the bolts and tighten them.
Tightening torque 9.5-14 Nm (7.0- 10.0 lb ft)