900 L4-1985cc 2.0L SOHC Turbo VIN S FI (1984)
Selector Shaft: Service and Repair
Selector Shaft
TO DISMANTLE THE SELECTOR SHAFT
Use a 4 mm drift to tap out the tubular dowel. Remove the spring, selector interlock device and actuator.
TO ASSEMBLE THE SELECTOR SHAFT
Assemble in the reverse order. See the figure for the locations. Make sure that there is an extra tubular dowel inside the actuator tubular dowel.
1. Shaft
2. Actuator
3. Selector interlock device
4. Reverse brake spring
5. Selector guide
6. Tubular dowel
NOTE: The reverse lever need not be removed from the selector shaft when the shaft is removed. The threads of the bolt retaining the reverse
lever are locked with locking compound, and the bolt may therefore fail if an attempt is made to remove it.
Make sure not to hammer the tubular dowel in too far during assembly.
1. Selector rod
2. Actuator
3. Selector interlock device
4. Spring
5. Tubular dowel