900 L4-2118cc 2.1L DOHC (1992)
5. Unhook the spring.
6. Remove the latching handle pivot bolt and lift oft the latching handle assembly. Transfer the bolt, washer and bush to the new assembly.
To fit
1. Lift the latching handle assembly into position, insert the pivot bolt, bush and washer and tighten the bolt.
2. Hook on the spring.
3. Fit the two screws securing the latching handle assembly to the no. 1 cross member.
4. Fit and tighten the two nuts and the Phillips screw securing the assembly to the front section of the side rail.
5. Screw in the screw at the front of the seal retainer.