900 L4-2118cc 2.1L DOHC (1992)
Wheel Speed Sensor: Service and Repair
Front
1.
Disconnect battery ground cable.
2.
Disconnect sensor lead connector for each wheel, lead connectors are located in the engine compartment.
3.
Raise and support front of vehicle, then remove wheel.
4.
Pull sensor lead from guide and rubber grommet on wheelwell.
5.
Remove sensor retaining screw from caliper, then the sensor.
6.
Reverse procedure to install, bleed brake system, refer to BLEEDING BRAKES then switch ignition on to ensure brake and ABS warning lights
go off.
Rear
1.
Disconnect battery ground cable.
2.
Disconnect sensor lead located under the rear seat.
3.
Raise and support rear of vehicle, then remove wheel.
4.
Pull sensor lead through rubber grommet on floor.
5.
Remove handbrake cable to suspension arm securing clip.
6.
Release sensor lead from guide on back of suspension arm.
7.
Remove sensor retaining screw from caliper, then the sensor.
8.
Reverse procedure to install, bleed brake system, refer to BLEEDING BRAKES then switch ignition on to ensure brake and ABS warning lights
go off.
