saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Sensors and Switches - Wiper and Washer Systems > < Trunk Light/Heated Rear Window Switch - Replacement|Page 502
Page 6
background image

18.

Refit the side trim, the cover over the rear bumper sill and sealing Strip.

19.

To ensure reliable operation, the rubber stops on the trunk lid must be replaced. Unscrew the old rubber stops from the trunk lid and attach the new
ones, P/N 43 04 234.

Adjust the stops so that the trunk lid closes correctly.

20.

Put the spare wheel back in place and secure it.

21.

Refit the press stud securing the top well lining at the top left-hand corner in the cabin.

Warranty Information

For a vehicle under warranty, a claim may be submitted using the following information:

Failure Coding 36436-62-2-01-01.
Time allowance is 0.3 hour which should be entered as straight time.

Action:

Heated Rear Window:

1.

Remove the mercury switch and cut the leads at the switch housing.

Strip the ends of the leads and join them by clamping them together in cable terminal, P/N 95 52 126.

Insulate the cable terminal with 30-40mm of shrink tubing. Bend the leads down and attach them in the clip above the connector.

IMPORTANT

Without the mercury switch installed, the heated rear window may be activated even when the top is lowered and there is a risk that the top
fabric can be damaged by the heating element in the rear window.

On cars without a time delay relay for the heated rear window, the standard relay must be replaced by a time relay that automatically turns off the
heated rear window 10-15 minutes after activation.

2.

Release and raise the rear seat so that the rear main fuse box is accessible. Replace standard relay P/N 85 22 310 at relay position B with time
relay P/N 95 19 133.

3.

Remove dashboard switch P/N 95 23 721 and replace it with dashboard switch P/N 95 23 820 for the time relay.

4.

Check that the heated rear window operates properly and that the time relay turns off the current 10-15 minutes after activation.

Warranty Information:

For vehicles under warranty, a claim may be submitted using the following information:

Failure Coding 36448-62-3-01-01.

Time allowance for step 1 above is Operation No. 36448 (0.5 hour).

Time allowance for steps 2-4 above is Operation No. 36424 (0.2 hour).

Sensors and Switches - Wiper and Washer Systems > < Trunk Light/Heated Rear Window Switch - Replacement|Page 502