900 L4-2118cc 2.1L DOHC (1992)
system with clean hydraulic fluid.
TO ASSEMBLE
Fit the return spring and spring seat. Lubricate the piston and seals thoroughly with Girling Rubber Grease 3, and fit the seal, washer and piston
with seals.
Correct position of the washer
NOTE: Take care to fit the washer with the convex side towards the piston as shown in the figure. Fit the push-rod into the cylinder, and then fit
the washer and circlip into the cylinder housing groove. Fit the dust cover or fit a new cover if the old one is damaged.
TO FIT
1. Fit the master cylinder to the bulkhead, fit the nuts and tighten them lightly.